Table of Contents
Advertisement
REAR
@) FM antenna (aerial) terminals (75 ohms)
@ FM antenna (aerial) jack (75 ohms)
@ AM loop antenna terminals
@ AM external antenna terminal
@ CD input jack
@) PHONO terminal (For HT-MD10
only)
@ Radio interference frequency (RIF)
cancel switch
@ Speakers terminals
PRECAUTIONS
@ Never use strong detergents or solvents for clean-
@ Be careful not to damage the power supply cord.
ing the cabinet of this unit as they could damage
Be sure to hold the plug when pulling it out; do not
the surface finish.
pull the cord.
@ Protect the unit against excessive heat (e.g, direct
sunlight), dust and moisture.
TUNER OPERATION
Note: When operating the tuner, set the Power of CD player to "OFF"
1. Insert the power supply cord into a convenient AC
5. Adjust the Volume control
@ and Graphic equa-
outlet and press the Power switch @ to the "ON"
lizer controls @.
position then, Power indicator @ lights.
6. Adjust the Balance control
© so that the sound
2. Set the Function selector
to the "TUNER" posi-
seems to come from a point midway between the
tion.
two loudspeakers.
3. Press the FM/AM selector © (and MW/LW selec-
7. To turn off the radio, set the Power switch @ to
tor ®) to select the desired band.
"OFF".
4. Turn the Tuning control
@ to select the desired
Station.
i
:
3
=
=
ANTENNA (AERIAL) INFORMATION
It is necessary to connect an external antenna (aer-
ial) [either a dipole or outside
antenna
(aerial)] to
|
75 ohms
i
the FM antenna (aerial) socket (75 ohms) @ or FM
|
|
! coaxial
; cable
antenna (aerial) terminals (75 ohms) @
Advertisement
Table of Contents
