Factory Supplied Accessories - Hitachi SOR-NEC Installation And Operation Manual

Factory supplied accessories

The operation is continued even if there is no person in a room.
- Object such as a curtain or a leafy plant is swaying in the
wind in the detecting area.
- Moving animal or insect is in the detecting area.
- Airflow returns to the motion sensor kit by hitting
obstacles such as shelf, locker, etc.
- Direct lights such as sunlight or headlight from outside
enters the detecting area.
- Hot air from a heater, etc. affects directly to the motion
sensor kit.
- Blower device such as ceiling fan or ventilating fan
affects the airflow from the indoor unit.
- Ambient temperature changes drastically.
- Excessive force or vibration is applied to the motion
sensor kit.
- Fluid or corrosive gas exists on the installing site.
- Continuous use of the indoor unit in a high humidity
environment.
- Weather affects directly to the surface of the motion
sensor.
- Static electricity or electromagnetic wave is generated on
the installing area.
- Moving object with temperature different from
surrounding.
3 FACTORY SUPPLIED ACCESSORIES
Check to ensure that the following accessories are packed with the motion sensor kit.
Nº
Motion sensor Kit

Cord band

Installation Manual

2 PMML0368A rev.0 - 06/2015 - P5415640
Accessory
Pay attention that the detecting function is decreased if the lens
for sensor smudges.
In this case, wipe off smudges by a cotton swab soaked
alcohol (Isopropyl alcohol is recommended.) or a soft cloth.
(When wiping off smudges on the lens for sensor, do not apply
excessive force.
If excessive force is applied, the resin lens may be damaged
so that may cause malfunctions such as misdetection or
undetectable of the motion.)
!
C A U T I O N
• Perform securely the installation work referring to this installation
manual. If the installation is not completed, it may cause injury by
falling down the motion sensor kit.
• Do not install the motion sensor kit where the flammable gases may
generate or enter.
• Turn OFF the power source completely before performing the
installation work and the electrical wiring work for motion sensor kit.
If not, it may cause an electric shock.
• Do not apply excessive force to remove the corner pocket cover.
Otherwise, it may cause of deformation or damage of the plastic
hook, or may result injury.
• Hold the air panel securely by hands to prevent it from falling when
it is removed.
• Perform securely the electrical wiring work. If the electrical work is
not completed, heat generation at the connection, a fire or an electric
shock may occur.
• Make sure that the electrical wires are securely fixed in order not to
apply an external force to the terminal connections of the wirings. If
fixing is not completed, it may cause heat generation or a fire.
Quantity
1 with connecting cable
1 for fixing cable
1 -
Remarks