Philips AVENT SCF263 Quick Start Manual

Trainer Cup
Tasse
d'Apprentissage
Vaso Entrenador
SCF263
www.philips.com/avent
Philips Consumer Lifestyle B.V.
Tussendiepen 4, 9206 AD Drachten,
The Netherlands / les Pays-Bas / Países Bajos
Trademarks are the property of Koninklijke
Philips N.V. / Les marques commerciales
sont la propriété de Koninklijke Philips N.V. /
Las marcas comerciales son propiedad de
Koninklijke Philips N.V.
© 2023 Koninklijke Philips N.V.
All rights reserved. / Tous droits réservés. /
Todos los derechos reservados.
3000.096.8572.2 (21/11/2023)
FSC
ENGLISH
Read all instructions carefully before use.
Keep the user manual and product
packaging for future reference.
For your child's safety and health
WARNING!
- Continuous and prolonged sucking of
fluids will cause tooth decay.
- Always check food temperature before
feeding.
- Throw away at the first signs of damage
or weakness.
- Keep components not in use out of the
reach of children.
- Never attach to cords, ribbons, laces or
loose parts of clothing. The child can be
strangled.
- Never use feeding teats as a soother.
- Always use this product with adult
supervision.
It is not recommended to use a microwave
to warm up baby food or drinks. Microwaves
may destroy valuable nutrients in food/
drinks and may produce localized high
temperatures. If you decide to use the
microwave, take extra care to stir heated
food/drinks to ensure even heat distribution
and check the temperature before serving.
Only place the container in the microwave,
without the screw ring, teat and cap.
Do not allow children to play with small
parts or walk/run while using bottles or
cups. Always discard any breast milk that is
left over at the end of a feed. Inspect before
each use and pull the feeding teat in all
directions. Throw away at the first signs of
damage or weakness. Do not use trainer cup
parts with glass bottles.
Before first use
Disassemble all parts, clean and then
sterilize the parts by placing in boiling water
for 5 minutes or sterilize by using a Philips
Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that the feeding teat is fully
pulled through the screw ring as shown in
the image (Fig. 1, 2).
Cleaning and storage
Clean all parts before each use to ensure
hygiene. After each use, disassemble all
parts, wash in warm, soapy water, remove
any food residues and rinse thoroughly. If
you use a brush to clean the tip of the
feeding teat, clean it as carefully as possible
to avoid damage. Then sterilize using a
Philips Avent sterilizer or boil for 5 minutes.
Make sure that you wash your hands
thoroughly and that the surfaces are clean
before contact with sterilized components.
During sterilization with boiling water,
prevent the parts from touching the side of
the pot. This can cause irreversible product
deformation, defect or damage that Philips
cannot be held liable for. Food colorings may
discolor parts. This product is dishwasher
safe. Do not place the product in a heated
oven. Do not bring the cup parts in contact
with or place on surfaces with abrasive or
antibacterial cleaning agents. We recommend
replacing feeding teats every 3 months. Keep
feeding teats in a dry, covered container.
Do not leave a feeding teat in direct sunlight
or heat, or leave in disinfectant (sterilizing
solution) for longer than recommended, as
this may weaken the teat.
Compatibility
Replacement teats are available separately.
To learn more about choosing the right teat
for your baby, visit us at
www.philips.com/avent. These cup parts
are compatible only with Philips Avent
Natural teats.
Support
If you need information or support, please
visit www.philips.com/support.
1 2