Safety Notice; Specification And Technical Data; Specification Drawings; Structure, Function And Maintenance Standard Engine And Cooling System Sen00380-01 Engine And Cooling System - Komatsu PC800LC-8 Shop Manual

SEN00376-04

Safety notice

Important safety notice
Proper service and repair are extremely important for safe machine operation. The service and repair
techniques recommended by Komatsu and described in this manual are both effective and safe.
Some of these techniques require the use of tools specially designed by Komatsu for the specific
purpose.
To prevent injury to workers, the symbol
cautions accompanying these symbols should always be followed carefully. If any dangerous situa-
tion arises or may possibly arise, first consider safety, and take the necessary actions to deal with
the situation.
1. General precautions
k
Mistakes in operation are extremely
dangerous. Read the Operation and
Maintenance Manual carefully before
operating the machine. In addition,
read this manual and understand its
contents before starting the work.
1) Before carrying out any greasing or
repairs, read all the safety labels stuck to
the machine. For the locations of the
safety labels and detailed explanation of
precautions, see the Operation and Main-
tenance Manual.
2) Decide a place in the repair workshop to
keep tools and removed parts. Always
keep the tools and parts in their correct
places. Always keep the work area clean
and make sure that there is no dirt, water,
or oil on the floor. Smoke only in the areas
provided for smoking. Never smoke while
working.
3) When carrying out any operation, always
wear safety shoes and helmet. Do not
wear loose work clothes, or clothes with
buttons missing.
Always wear safety glasses when hit-
q
ting parts with a hammer.
Always wear safety glasses when
q
grinding parts with a grinder, etc.
4) When carrying out any operation with 2 or
more workers, always agree on the oper-
ating procedure before starting. Always
inform your fellow workers before starting
any step of the operation. Before starting
work, hang UNDER REPAIR warning
signs in the operator's compartment.
5) Only qualified workers must carry out work
and operation which require license or
qualification.
6) Keep all tools in good condition, learn the
correct way to use them, and use the
proper ones of them. Before starting work,
thoroughly check the tools, machine, fork-
lift, service car, etc.
2
k
is used to mark safety precautions in this manual. The
7) If welding repairs are needed, always
have a trained and experienced welder
carry out the work. When carrying out
weld in g wo rk , al way s wear wel din g
gloves, apron, shielding goggles, cap and
other clothes suited for welding work.
8) Before starting work, warm up your body
thoroughly to start work under good condi-
tion.
9) Avoid continuing work for long hours and
take rests at proper intervals to keep your
body in good condition. Take rests in
specified safe places.
Safety points
1 Good arrangement
2 Correct work clothes
3 Following work standard
4 Making and checking signs
Prohibition of operation and handling by
5
unlicensed workers
6 Safety check before starting work
Wearing protective goggles
7
(for cleaning or grinding work)
Wearing shielding goggles and protectors
8
(for welding work)
9 Good physical condition and preparation
Precautions against work which you are
10
not used to or you are used to too much
00 Index and foreword
1
(Rev. 2008/08)
PC800, 850-8