Table of Contents
Advertisement
Basic Procedure for DME Wipe Settings
You carry out DME wipe setting operations principally using the DME Wipe
menu for each of the M/E-1 to M/E-3 and PGM/PST banks.
This section describes the basic procedures for DME wipe settings, taking the
M/E-1 >DME Wipe menu as an example.
For details of independent key transition DME wipe settings, see "DME Wipe
Settings for Independent Key Transitions" (page 423).
Notes
• To carry out DME wipes requires the BKDS-9470 DME Board Set or the
• For one M/E bank, DME effects (including external processed keys) can be
DME Wipe Settings Menu
Accessing the DME Wipe menu
To access the M/E-1 >DME Wipe menu, use any of the following operations.
• In the menu control block, select the top menu selection button [M/E 1], and
• In the transition control block of the M/E-1 bank, press the transition type
• In the Flexi Pad control block of the M/E-1 bank, press the [DME] button
Any of the above operations displays the M/E-1 >DME Wipe menu.
DME Wipe Pattern Selection
You can select a DME wipe pattern in the DME Wipe menu, or by entering a
pattern number from the Flexi Pad control block.
Selecting a DME wipe pattern by a menu operation
1
412
Basic Procedure for DME Wipe Settings
MVE-8000A/9000 DME Processor.
used in up to two places on the DME dedicated interface and in only one
place on the SDI interface simultaneously.
press VF6 'DME Wipe.'
selection button [DME] twice in rapid succession.
twice in rapid succession.
In the M/E-1 >DME Wipe menu, select HF1 '1ch' for one-channel mode,
HF2 '2ch' for two-channel mode or HF3 '3ch' for three-channel mode.
Advertisement
Table of Contents
