Table of Contents
Advertisement
When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.
For the method of using a color matte signal, see "Freezing an image and
writing it to memory" (page 440).
Selecting the signal on a frame memory source bus
As an example, to select a signal on frame memory source bus 1, use the
following procedure.
1
In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see "AUX
Delegation Buttons Settings (Aux Assign Menu)" in Chapter 16 (Volume
2).
2
In the auxiliary bus control block cross-point buttons, select the signal to
be used for the input image.
To select a signal with a key or DME effect applied on the frame
memory source bus
In the key control block, press the [FM FEED] button, turning it on.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Selecting Outputs and Target Frame Memory
Selecting outputs (FM) and target frame memory
The following description applies to the case of settings for FM1&2, but the
procedures are similar for the other cases.
1
In the Frame Memory menu, press one of VF1 to VF4, and select the
required HF menu.
The current status of frame memory appears. (See page 434).
2
From the pair selection buttons, press the buttons corresponding to FM1
and FM2.
This assigns the signals to FM1 and FM2.
439
Still Image Operations
Advertisement
Table of Contents
