Sony STR-DG710 Operating Instructions Manual page 29

1
2
Input
MASTER
Press AMP MENU.
Press AUTO CAL.
Measurement sturts ill 5 seconds und tile
display changes as follows:
A.CAL [5] -_ A.CAL 141 -_ A.CAL [3]
-_ A.CAL [21 -_ A.CAL Ill
While the time is counting down, stand
away l¥om the measurement area to avoid
measurement erron
3
Measurement starts.
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
Measurement for Display
Environn/ent noise NOISE.('HK
level
Speaker connection MEASURE and SP
DET. appears
alternately _-
Speaker level MEASURE and GAIN
appears alternately'
Speaker distance MEASURE and
DISTANCE appears
alternately _-
4
5
: The corresponding speaker indicator lights
up in tile display during measurement.
Measurement ends.
"COMPLETE" appears on the display
and the settings are registered.
Disconnect the optimizer
microphone from the AUTO
CAL MIC jack.
Note
Auto C_dibr_ttion cnnnot detect the sllb woofer.
Therefore. all sub woofer settings will be
maintained.
Tip
During tile measurement process. Auto Calibr:_tion
is canceled when you do the lbllowing.
Press I/_), input buttons or MUTING.
Change the volume level.
Press AUTO CAL again.
I'D
-I
I'D
29 us