Shifting - Yamaha FZ07HC 2016 Owner's Manual

Operation and important riding points
light (except the oil pressure
warning light) remains on, see
page 4-2 for the corresponding
warning light circuit check.
 After going off once, the oil
pressure warning
come back on until the engine is
started. If the warning light does
not come on, or if the warning
light does not go off after start-
ing the engine, see page 4-2 for
the engine oil pressure warning
light circuit check.
6
For ABS models:
The ABS warning light should
come on when the key is turned to
"ON", and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
or higher.
NOTICE
If the ABS warning light does not
come on and then go off as ex-
plained above, see page 4-2 for the
warning light circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
light will 3. Start the engine by sliding the
switch toward "
If the engine fails to start, release
the start/engine stop switch, wait
a few seconds, and then try again.
Each starting attempt should be
as short as possible to preserve
the battery. Do not crank the en-
gine more than 10 seconds on any
one attempt.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA17682

Shifting

".
1. Shift pedal
2. Neutral position
Shifting gears lets you control the
amount of engine power available for
ECA11043
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
TIP
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
6-2
EAU16673
6
5
4
3
2
N
1
2 1