Rear Wheel (For Non-Abs Models) - Yamaha FZ07HC 2016 Owner's Manual

2. Insert the wheel axle from the right
side.
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
4. Install the brake calipers and the
reflectors by installing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holder by in-
stalling the bolt.
6. Tighten the brake caliper bolts and
the brake hose holder bolt to the
specified torques.
Tightening torques:
Brake caliper bolt:
40 N·m (4.0 kgf·m, 29 lb·ft)
Brake hose holder bolt:
7 N·m (0.7 kgf·m, 5.1 lb·ft)
7. Tighten the wheel axle, and then
the wheel axle pinch bolt to the
specified torques.
Periodic maintenance and adjustment
Tightening torques:
Wheel axle:
65 N·m (6.5 kgf·m, 47 lb·ft)
Front wheel axle pinch bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
8. Push down hard on the handlebar
several times to check for proper
fork operation.
7-40
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut.
EAU44802
EWA14841
EAU59943
EWA10822
7