Advertisement
NOTICE
Attention for Use
●
Make sure to hold the main body of the product with your hand
touching back plate and apply the head of the product to your skin.
Otherwise, the product will not be operated.
Back plate
About Skin Testing Function
●
This product which is operated through the human body.
●
The electric circuit operates on skin in contact with the back plate
and the head of the product.
●
The product may keep on operating even after the head is moved
away from skin, but this is not a failure. In such a case, it can be
stopped by turning off the power switch or releasing the back plate.
About Operating Time
●
The continuous operating time of each mode is default.
The time is not included under below circumstances:
●
When the head or the head attached with cotton puff
●
and back plate are not contacted with skin continuously.
The cotton puff does not contain enough toner.
●
＊ The actual operating time normally would be longer.
About Auto-off Function
●
If the product is not in operation around 3 minutes,
the power will turn off automatically.
●
There is an ending sound given and the product will turn
off automatically when each mode is completed.
-15-
FAQs
No.
Questions
Answers
・ Check the intensity level. If it is set on "High" level,
Q1
Tingling sensation is felt
press the level switch button to switch to "Low" level.
on the skin.
・ If toner in the cotton pad wears off, replenish it again.
※ If you still feel uncomfortable on the skin, stop using
the product immediately and consult a dermatologist.
・ This product cannot remove makeup.
Q2
Can "HOT CLEANSING"
mode remove makeup?
Please use a makeup remover cleanser.
・ Electric power is used for removing dirt and
Q3
Will dirt be more easily
moisturizing. Thus, by applying more force,
removed by applying
it will not make any difference.
more force?
・ Gently apply to skin and massage slowly.
・ Use a normal rectangular or round cosmetic
Q4
Cotton pad cannot be
attached properly.
cotton pad.
(If the cotton pad is too thick or thin, it will
not be able to attach.)
・ This product is not waterproof.
Q5
Can the product be used
・ Never use or place this product in wet and
in the bathroom?
damp areas, e.g. bathroom.
・ Yes but it will not enhance the cooling effects.
Q6
Does the "COOL" mode
work with toner?
・ The "COOL" mode automatically
Q7
The cooling head does not
feel cool during the "COOL"
stops after being used around 2 minutes.
Approximately 10 seconds is required at the start of
mode.
the mode before the cooling effect takes place.
It will last for another 1 minute 50 seconds before it
stops automatically.
・ The "COOL" mode may be used continuously and
continuous use will reduce the cooling effect.
・ Milk-based lotion or gel can be used when using
Q8
Can I use milky lotion or gel?
"HOT MOISTURIZE" mode without cotton pad and
"HOT MASK" mode.
Please refer to the "About mode switching" in the
"Preparation before use" section in the instruction
manual for details.
・ This product is not for whitening or removing blemish.
Q9
Does this product have
・ It will pull out fine dirt that remains deep in the pores
whitening or blemish
removal function?
and penetrate moisture into the skin.
・ Please refer to the instruction manual for the
Q10
Which regions are not
suitable to use this product?
list of regions.
-16-
Advertisement
