LG MAGNIT Owner's Manual page 59

[LED Local Dimming]
Make the light areas of the screen lighter and the dark areas darker for maximum contrast.
NOTE
• Return to default settings by clicking [Admin] -> [Factory Reset].
[Average Picture Level Auto Control]
Can use image quality control based on APL (Average Picture Level) of the monitor input image. When using the
monitor as a Video Wall, it is recommended to set this function off to prevent an image quality difference between the
monitors.
NOTE
• Return to default settings by clicking [Admin] -> [Factory Reset].
[Low Latency]
Sets whether to use dithering processing.
• [Off]: Use dithering processing.
• [On]: Do not use dithering processing. Since frame delay does not occur due to dithering processing, it is
recommended to be used when delay is sensitive.
[Dynamic Brightness]
Set whether to use the peak luminance that can produce the maximum brightness in a local area.
• [Off]: Do not use peak luminance. The brightness that can be expressed at the maximum decreases and the ability to
express low gradations improves.
• [On]: Use peak luminance. The brightness that can be expressed to the maximum increases, and the expressive power
of low gradation deteriorates.
[Genlock]
When the Genlock signal is connected to the REF IN port and the Genlock feature is turned on, the monitor can use the
video signal synchronisation feature.
• [Off] : Genlock is disabled
• [On] : Genlock is enabled
NOTE
• Genlock setting of video source equipment is more important than Genlock of LED System Controller.
59