Kenmore 911.9554591 Owner's Manual page 6

PROTECTING YOUR NEWCOOKTOP
o
o
Do not slide cookware across your cooktop.
Do not use a dish towel or sponge to clean
or wipe down .your cooktopo
• Do not use scouring powders or plastic,
nylon or metal cleaning pads on your
cooktop.
• Do not apply your cooktop cleaning creme
to the cooktop surface ff the surface is hoL
,* Read the instruction label on the cooktop
cleaning creme bottle before attempting to
clean the surface of your cooktop.
• Aftercleaning the cooktop surface, be sure
to wipe off any residue that may be left from
the creme with a dry paper towel.
,, For major spills, turn the surface control
knob to LO; use a dry paper towel to wipe
up spill, then use a razor scraper (held with
a potholder) at a 30 ° angle against the
surface of the cooktop to scrape remaining
spill from the hot cooking zone.
• Do not cook directly on the surface of the
glass,
• Do not use the cooktop as a cutting board.
surface
150°F.
CAUTION: When the surface
controls are turned off, the Hot
Surface indicator light will
remain lit until the cooktop
has cooled to approximately
The glass ceramic surface will
retain heat after the indicator light goes
ouL Use caution until the cooktop
surface has had time to cool
To remove the adhesive left from packaging
tape, use household dishwashing fiquid,
mineral oil or cooking oil,, With a soft cloth rub
into the area and allow to soak,, Rinse and dpy
well, Repeat procedure using an appliance
polish to insure no damage is done to the
oven_ This should be done before the
range is turned on for the first time.
The tape cannot be removed once the
oven has heated.
Packaging tape can be found in the
following areas:
Cooktop surface
Door handle
Control panel area
Door trim
Oven area
6