Philips N4450 Operating Instructions Manual page 15

Hide thumbs Also See for N4450:

Table of Contents

e If you wish to listen in during recording, you may now

adjust volume, balance and tone with controls

32... 35.

@ To start the recording, press the appropriate start key

for tape transport (16 or 19). Occasionally check the re-

cording level and, if necessary, readjust it gradually.

@ As long as the tape is running, you may choose between

before and after-tape monitoring (switch 10).

Monitoring is now possible only in position "B" of the

before/after-tape monitoring switch (10).

you may also press one of the fast wind keys (20 or 22).

Note: If during recording (with running tape) the other

start key for tape transport is pressed, the recording

function is not switched off. The recorder then continues

recording in the other direction.

3.6. ERASING WITHOUT RECORDING

During recording any previous recording on the same part

of the tape is automatically erased. A recording may also

be erased without recording over it:

on the tracks to be erased. (In position "ST" two tracks, 1

and 3 or 4 and 2 are erased at the same time; in position

"1-4" or "3-2" one track is erased at a time).

@ Press one of the start keys for tape transport (16 or 19)

together with the record key (17).

4. PLAYING BACK AND USING THE AMPLIFIER

SECTION

4.1. THE AMPLIFIER

a. Via two loudspeaker enclosures (4-8 ohm)

b. Via stereo headphones

c. Via a monitor amplifier

An additional amplifier can be connected to socket

"MONITOR" (46). Volume etc. can then be adjusted on the

external amplifier. The volume controls etc. of N 4450 do not

affect the output signal on the "MONITOR" socket (46).

4.3. USING N 4450 AS AN AMPLIFIER

Table of Contents