Maintenance; Remote Control - Philips N4450 Operating Instructions Manual

For splicing use special splicing tape. You can also use the
Philips' splicing kit SK10.
Proceed as follows :
@ Pull the cover below the tape slot forwards.
@ Open the two black tape clips (Fig. 9).
© Insert the correct-part of the tape in the jig and close the
clips. The side of the tape facing the heads (dull side) should
face downwards. During splicing the reels need not be
removed from the recorder.
® Cut the parts to be removed by inserting a non-magnetic
tape-cutter in the diagonal guide slot (an oblique splice is
not audible during playback).
@ Place the ends to be spliced accurately against each other,
@ Apply a piece of adhesive tape of approx. 2 cm across the
ends. Check that the adhesive tape does not overlap the
magnetic tape; if necessary, cut off the protruding part.
Note: Take care that no pieces of tape drop into the recorder
during splicing: this may disturb the correct working of the
recorder.
7. REMOTE CONTROL
8. CONTINUOUS TAPE REEL
The continuous tape reel EL 1907/52 (CE 10) can also be
mounted on the recorder.
be tightened too firmly.
9. SLIDE SYNCHRONISER
68
10. MAINTENANCE
Storage of tapes