Philips 24B1D5600 User Manual page 10

Without power adapter connected to the
monitor:
The EPD is able to be powered by device
through USB-C2 which support up to
65W with 5V/3A, 7V/3A, 9V/3A, 10V/3A,
12V/3A, 15V/3A, 20V/3.25A.
Note
It is highly recommended to connect to
the power adapter when using a mobile
phone with the monitor for better use.
Please note, the screen may flicker or go
black when the battery on your device
is low. Connect power to resolve this
situation.
USB C2
≥15W
5
USB C driver installation for RJ45
Before using the USB C docking display,
please ensure to install the USB C driver.
You can find the "LAN Drivers" from CD
disk if bundled or go to Philips website
support page to download the driver.
Please follow the steps for the
installation:
1. Install the LAN driver that matches
your system.
2. Double click driver to install, and
follow Window's instructions to
proceed with installation.
3. It will show "success" when the
installation is finished.
4. You must reboot your computer after
the installation has completed.
5. Now you will be able to see "Realtek
USB Ethernet Network Adapter" from
your program installed list.
6. We recommend to periodically visit
the above web link to check for the
availability of the most updated
driver.
USB hub
6
To comply with International energy
standards, the USB hub/ports of this
display are disabled during Standby and
Off modes.
Connected USB devices will not work in
this state.
To permanently put the USB function in
"ON" state, please go to OSD Menu, then
select "USB standby mode", and switch it
to "ON" state. Somehow if your monitor
reset to factory setting, ensure to select
"USB standby mode" to "ON" state in OSD
menu.
8