Philips AE 3750 Instructions For Use Manual page 4

TOP AND FRONT PANEL
Controls
General
<D POWER - for switching the radio on and off
<D LOCK fl - for locking all controls apart from
POWER off and the REPEAT ALARM
controls
© - to switch the display light on and off
© DISPLAY - provides information about the
functioning of the world receiver
© ENTER - to confirm an entry
© 0-9 - for numeric entries
- frequencies and meter bands
- time settings
- stored stations positions
© • - - decimal point
- to clear incorrect numeric entries
® RESET - to clear all stored data, and to start
up the set again
Clock functions
@ REPEAT ALARM - to switch off the wake
up call temporarily or for 24 hours during
the alarm call.
® ALARM FUNCTIONS
• ALARM TIME
- to set the alarm time
- to check the set alarm time when the
radio is on
• DUAL TIME
- to set/review the two different clock
times
- to select the time display for time 1 or
DUAL TIME (time 2)
• RADIO/BUZZ - to activate/deactivate the
different alarm modes:
- : wake up with radio
- A : wake up with buzz sound signal
- - (no symbol): alarm deactivated
• SLEEP - for switching on the sleep function
and setting the sleep time
Radio
® RADIO FUNCTIONS
• PRESET A/v - to search and select stored
radio stations
• PROGRAM - to store up to 40 radio
stations in the memory
• STEP - to select the tuning steps:
MW -1 kHz or 9 kHz or 10 kHz
SW-1 kHz or 5 kHz
LW-lkHz or 9 kHz
• MW-SW-LW
- to select MW, SW or LW bands
- to clear incorrect numeric entries
• TUNING +/-■ - to manually tune up or down
SCAN - for automatic tuning to stations of
higher/lower frequencies
• FM
- to select the FM band
- to clear incorrect numeric entries
FREE PRESET
- to show free memory positions for radio
stations
- to clear an occupied memory position
• ENTER - to enter frequencies/meter
bands
@ Telescopic aerial - to improve FM and SW
reception
SIDE PANELS_
® 9V DC IN, ©-<B-© - socket for 9 volt mains
adaptor
@0-3.5 mm headphone socket
(The speakers are automatically muted
when the headphones are inserted.)
® MONO/STEREO - to select FM reception
in mono/stereo sound CD.
Note: The sound heard in speaker mode
will always be MONO. Selection of
FM STEREO sound can be heard
when using headphones
@ VOLUME - to adjust the level of sound
@ TONE - to select HIGH (trebIe)/LOW (bass)
tones
BACK PANEL_
® STAND - to support the set in tilted
position (with illustration of the time zones
to help set dual time clock setting)
® Battery compartment
4