Advertisement
USE OF LEARNING FUNCTIONS
Using the remote control unit of your VCR to program the
playback command.
¢ It is recommended that the name of the key and its func-
tion
correspond.
This
convenient
when
operating
equipment.
[Operation example]
1. Set the SR RECALL/USE/LEARN switch of the program-
mable remote control unit to the LEARN position and set
the
TRANSMISSION
mode
switch
to the
VIDEO
position.
¢ Programming is possible with the TRANSMIT mode
selector switch in any position, but VIDEO is used as
an example.
® PIONEER'
© tRaNsmiTiesrnn
AUDIO VIDEO
ee
sR
USE
RECALLS @ @LEARN
—
PaweR ————
AMP
TV
vcoR
V/AUX
TAPE
TUNER
PHONO
co
en i a
a Pe
PROGRAM
osc,
=CO/VOP
CHRIFR-TM SEARCH
VOP PGM DISPLAY
2. Place the transmission sections of the programmable
remote control unit and the remote control of the VCR
facing each other.
1 to 2 inches
© Place the two units on a table, separated by 2 to
5cm
(1 to 2 inches).
Memorization will not be possible if they are too close.
3. Hold down the VCR PLAY key of the programmable
remote control unit until the TRANSMIT/LEARN in-
dicator lights up, then release the key.
4. Hold down the PLAY key of the VCR remote control
unit.
5. Release the key of the VCR remote control unit after
making sure that the TRANSMIT/LEARN indicator
has gone out on the programmable remote control
unit.
NOTE:
If the LEARN indicator flashes, it indicates that you are trying
to preset a key not available for the learning function, or
otherwise the program capacity has been exceeded. In case
the program capacity has been exceeded, the function pro-
grammed last will not be memorized correctly. All previously
programmed functions, however, will be retained in memo-
ry and may be used as they are if the last function is not
essential. For re-programming refer to page 10 "Returning
to the Initial Settings".
6. Set the SR RECALL/USE/LEARN selector switch of the
programmable remote control unit to the USE position.
¢ The previous code (Pioneer uniform remote control
code or code for other equipment)
is erased and
replaced by the new code.
7. Check that the program works.
© Try actual operation and make sure the unit works
properly.
;
¢ If the VCR does not operate when pressing the key,
change angle, position and distance between both
remote control units and repeat the programming
procedure.
¢ When programming, make sure that the function indi-
cations (for example,
»,
wp,
Mf) on the other
remote control unit and the programmable
remote
control unit are the same. This will facilitate operation.
When teaching functions whose names differ from those
of the keys, write in the names or codes of the functions
on the included templates and place on the panel.
=)
<ARD1005>
Advertisement
