Table of Contents
Advertisement
Loading batteries
| Remove the cover by pressing
down on the ridged area, and
sliding it off in the direction of
the arrow.
2. Insert 2 AA-size batternes.
*
Be sure to pay attention to
the '+' and '-' signs when
you're inserting the batteries.
3 Close the cover.
an
——_
Sy
Tip:
.
The batteries that came with this
system are test batteries and may
not last as long as alkaline batteries
Balancing the
speaker levels
The speakers have been pre-
balanced at the factory for a typical
room, so your system should sound
good night out of the box. However,
if you're using your system in an
unusually-shaped room or just
want to fine-tune the sound
yourself, here's how to do it.
Before you start:
+
Make sure the room is as quiet
as possible.
Balancing your system
with test noise
I Sit in your usual listening location.
2 Point the remote at the nght
speaker and press the TEST
button.
* The system will turn on
automatically.
* You'll hear test noise circulate
between the channels in the
following order.
LEFT>CENTER>RIGHT>
SURROUND. The noise will
circulate once, then shut off.
3 Use the MASTER VOLUME
controls to adjust the volume so
it is reasonably (but not uncom-
fortably) loud.
4 Press the TEST button again, and
listen to the test noise level of
each speaker carefully. You may
have to press the TEST button
more than once while making
the adjustments.
5 Using the BALANCE keys, adjust
the balance between the left and
right speakers so the test noise
volume is the same in each
speaker.
* While you press the BALANCE
keys the test noise stops circulat-
ing and remains in the left or
right speaker, whichever one
you're adjusting.
6 Using the CENTER keys,
adjust the center speaker so
that the volume of the test
noise is the same as the left
and nght speakers.
*
While you press the CENTER
keys the test noise stops circulat-
ing and remains in the center
speaker.
7 Using the SURROUND keys,
adjust the surround speaker
so that the volume of the test
noise is the same as the left
and right speakers.
* While you press the SURROUND
keys the test noise stops circulat-
ing and remains in the surround
speaker.
8 When all of the speakers sound
like they're the same volume,
you've balanced your system.
Balancing the system
with movies or music
You can also fine-tune the speaker
level balance with the remote
control while watching movies
or listening to music.
Advertisement
Table of Contents
