Kenwood STS-1000 Setting Up And Using page 3

Centerstage instant home theater
Hide thumbs Also See for STS-1000:
Table of Contents

Advertisement

To maintain good ventilation, do not
put records or a table-cioth on the unit.
Place the unit at least 4 inches away
from'the walls.
Do not use the unt on a bed, sofa, rug or
similar surface that may biock the ventila-
tion openings. This unit should not be
placed in a built-in installation such as a
bookcase or rack unless proper ventila-
tion is provided or the manufacturer's
instructions have been adhered ta.
5
Water and moisture. The unit should
not be used near water. for example,
near a bathtub, washbowl, kitchen sink,
iaundry tub, in a wet basement, or near a
swimming pool, etc.
6
Temperature. The unt may not func-
tion properly if used at extremely low, or
freezing temperatures. The ideal ambient
temperature is above +41 °F.
7
Heat. The unit shoutd be situated away
from heat sources such as radiators, heat
registers. stoves, or other unrts (including
amplifiers) that produce heat.
8
Electric Shock. Care should be taken
so that objects do not fall and liquid is
not spilled into the enclosure through
openings. If a metal object. such as a hair
pin or a needle, comes into contact with
the inside of this unit, a dangerous electric
shock may result. For families with chil- -
dren, never permit children to put
anything, especially metal, inside this unit.
9
Enclosure removal. Never remove
the enclosure. If the internal parts are
touched accidentally, a senous electnc
shock might occur.
10 Cleaning. Unplug this unit from the wall
outlet before cieaning. Do not use
volatile solvents such as alcohol, paint
thinner, gasoline. or benzine, etc. to clean
the cabinet. Use a clean dry cloth
Lightning. For added protection for this
unit during a lightning storm. or when it is
left unattended and unused for long per-
ods of time. unplug it from the wall outlet
and disconnect the antenna or cable
system. This will prevent damage to the
unit due to lightning and power-line
surges.
42 Abnormal smell. If an abnormal smell
. or smoke is detected, immediately tum
the power OFF and unplug the unit from
the wall outlet. Contact your dealer or
nearest service center.
13 Damage requiring service. The unit
should be serviced by qualified service
personnel when
'
The power-supply cord or the plug has
been damaged.
Objects have fallen, or hquid has been
spilled into the unit.
The unit has been exposed to rain or
water,
5
The unit has been dropped. or the enclo-
sure damaged.
The unit exhibits a marked change in
performance.
The unit does not appear to operate
normaily by following the instruction
manual. Adjust only those controls that
are covered by the instruction manual as
an improper adjustment of other controis
may result in damage and wilt often
require extensive work by a qualified
technician to restore the unit to its
normal operation.
14 Servicing. The user should not attempt
to service the unit beyond that descnbed
an the instruction manual. All other servic-
ing should be referred to qualfied service
personnel
15 Power lines. An outside antenna
system should not be located in the vicin-
ity of overhead power lines or other elec-
inc light or power circuits, or where it
can fall into such power lines or circuits.
When installing an outside antenna
system, extreme care should be taken to
keep from touching such power lines or
circurts as contact with them might be
fatal.
16 AC outlets. Do not connect other
audio equipment with a power consump-
tion larger than that specified to the AC
outlet on the rear panel, Never connect
other electrical units, such as an iron or
toaster, to it to prevent fire or electric
shock,
17 Overloading. Do not overload wall
outlets, extension cords, or integral
convenience receptacles as this can result
in a risk of fire or electric shock.
'8 Attachment. Do not use attachments
not recommended by the unit manufac-
turer as they may cause hazards.
19 Replacement parts. When replace-
ment parts are required, be sure the
service technician has used replacement
parts specified by the manufacturer or
have the same characteristics as the ongi-
nal parts, Unauthonzed substitutions may
result in fire, electnc shock, or other
hazards.
20 Safety check. Upon completion of any
service or repairs to this unit, ask the
service technician to perform safety
checks to determine that the unit is in
proper operating condition.
2 . Carts and stands. Don't put this unit
on a cart or stand that ts unsteady or that
can not support the unit's weight. if you
move this unit on a cart or stand, be
careful-—quick stops, excessive force and
pushing over or uneven surfaces, may
cause the cart to overtum and damage
your equipment.
FCC Warning
This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may-cause harmful
interference untess the modifications are
expressly approved tn the instruction manual
The user could lose the authority to cperate
this equipment if an unauthonzed change or
modification is made.
Important
This equipment has been tested and found to
comply with the limits for a Class B digitai
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment may cause harmful interference to
radio communications if tt is not installed and
used in accordance with the instructions.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment OFF and ON. the user
is encouraged to try to correct the
interference by one or more of the following
measures:
¢
Reorent or relocate the receiving
antenna
e
Increase the separation between the
equipment and receiver
©
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected
¢
Consult the dealer or an experienced
radio/TV technician for help
Cable System Installer Notice
Article 820-40 of the NEC provides
guidelines for proper grounding and, in
particular, specifies that the cable ground shall
be connected to the grounding system of the
building, as close to the point of cable entry
as practical

Advertisement

Table of Contents
loading

Table of Contents