Sealey PC380M Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Vacuum cleaners of dust category M
instruction according to IEC/EN 60335-2-69 for
manual dry vacuuming of hazardous dusts
with an exposition limit value ≥0.1
mg/m3
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood.
Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2. GENERAL SAFETY
Safety precautions must be observed to avoid injuries and damage. Read the complete operating manual
9
carefully. Keep this manual in a safe place so that the information is always available to ANY users of the
equipment.
Never leave the appliance switched on unattended. If the operator leaves the work area, switch the appliance off or unplug it from the
9
power supply.
DO NOT vacuum or use this vacuum cleaner near flammable liquids, gases or explosive vapours like gasoline or other fuels,
8
lighter fluids, cleaners, oil-based paints, natural gas, hydrogen, or explosive dusts like coal dust, magnesium dust, grain dust or gun
power. Sparks inside the motor can ignite flammable vapours or dust.
This vacuum cleaner is not suitable for the vacuuming of asbestos or asbestos dust.
9
DO NOT vacuum anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
8
Ensure the hose and connections are always pointed away from the users face, hair, ears and eyes during operation and never direct
9
the nozzle towards persons or animals.
Clear the working area of any items or possessions that do not need to be vacuumed before using equipment
9
Keep mains cable away from heated surfaces.
9
DO NOT expose to rain. Store indoors.
8
DO NOT unplug by pulling on the mains cable. To unplug, grasp the plug, not the cable.
8
DO NOT use with damaged cord, plug or other parts.
8
DO NOT pull or carry by cable, use cable as handle, close a door on the cable, or pull cable around sharp edges or corners.
8
If the supply cord is damaged, it must be replaced by the manufacturer, a qualified service agent or similarly qualified persons in order
9
to avoid a hazard.
DO NOT handle the plug or vacuum cleaner with wet hands.
8
Frequently check that the float valve positioned underneath the motor is able to move freely.
9
DO NOT use this vacuum cleaner with a torn filter or without the filter installed.
8
© Jack Sealey Limited
38L DUST-FREE WET & DRY INDUSTRIAL
VACUUM CLEANER STAINLESS STEEL DRUM
CLASS M FILTRATION
PC380M
MODEL NO:
Wear protective
clothing
.
Original Language Version
Wear a P-2
respirator when
changing bags,
filter or
cartridges
Recommended fuse rating
13 Amp
PC380M Issue:1 08/04/21