Table of Contents
Advertisement
D.
Torque the locknuts to 20 to 25 N∙m (175
to 225 in-lb).
7.
Lubricate the grease fittings on the PTO
driveshaft.
8.
After you connect the other end of the driveshaft
to the attachment gearbox shaft, connect
the wire-harness connector to the PTO
solenoid-valve-coil connector
2
Using the Optional
Cutting-Unit-Mounting
Hardware
Parts needed for this procedure:
2
Retainer pin
2
Grease fitting
2
Washer head screw (5/16 x 7/8 inch)
Procedure
Note:
These components and procedure are required
only if a cutting unit that requires retainer pins is
mounted to the traction unit. Refer to the cutting unit
Operator's Manual for the installation instructions.
Note:
If you are not installing a cutting unit on the
traction unit, remove or tie up the 4 deck-lift chains
from the lift suspension.
3
Adjusting the Roll Bar
No Parts Required
Procedure
1.
Remove the 2 hairpins and the 2 pins from the
roll bar
(Figure
5).
2.
Raise the roll bar to the upright position and
secure it with the 2 pins and 2 hairpins
5).
Note:
If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove
the pins, lower the bar slowly, and secure it with
the pins so that it does not damage the hood.
(Figure
3).
(Figure
14
1. Roll bar
2. Pin
4
Checking the Tire Pressure
No Parts Required
Procedure
Check the tire pressure; refer to
Pressure (page
46).
Important:
Maintain pressure in all tires to
ensure a good quality-of-cut and proper machine
performance. Do not underinflate the tires.
5
Checking the Fluid Levels
No Parts Required
Procedure
1.
Check the hydraulic-fluid level before starting
the engine, refer to
System (page
51).
2.
Check the engine-oil level before starting the
engine, refer to
Checking the Engine-Oil Level
(page
38).
Figure 5
3. Hairpin
Checking the Tire
Checking the Hydraulic
g014166
Advertisement
Table of Contents
