Table of Contents
Advertisement
3.
Check the cooling system before starting the
engine; refer to
Checking the Cooling System
(page
47).
6
Installing the Decal (CE
Machines Only)
Parts needed for this procedure:
1
Model year decal
Procedure
Install the model year decal next to the serial number
plate on the machine
(Figure
Note:
For EN ISO 5395, complete the installation of
the CE Kit. Contact your authorized Toro distributor
for the correct CE Kit.
1. Model year decal
6).
Figure 6
Product Overview
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Traction Pedal
The traction pedal
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. The ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop the machine, reduce the foot pressure on
the traction pedal and allow it to return to the center
position.
g278147
1. Parking brake
2. Brake pedal
Brake Pedal
Use the brake pedal with the brake-pedal latch to
engage and disengage the parking brake
7). To stop the machine, release the traction pedal
and allow it to return to the center position. You can
use the brake to assist in stopping the machine in an
emergency situation.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure
7). To move the steering wheel away from
15
(Figure
7) controls the forward and
position.
AST
Figure 7
3. Tilt-steering pedal
4. Traction pedal
g197397
(Figure
Advertisement
Table of Contents
