Advertisement
7. MECHANISM
EXPLODED
VIEW
Figure 23.
ee
|
|
| _KT-R2
KT-R2
|
(1)
(2)
Figure 24.
8. MOTOR
REPLACEMENT
1. MOTOR
PULLEY
REMOVAL
Put a preheated
soldering
iron on the upper part of the
pulley
to melt the metal glue between
the motor pulley
and
the
shaft
of the motor
and
pull the motor
pulley
upward strongly. (See Fig. 25)
Caution: Do not scorch your fingers.
2. MOTOR
PULLEY
INSTALLATION
Maintain
a gap (1mm)
between
motor
and motor
pulley as shown
in Fig. 26 and apply a little metal
glue, LOCTITE
601 (22964085) from the top of the
motor pulley.
Spread the glue between
them
by reciprocating the
pulley and then fix it while keeping the adequate gap
for one minute.
Caution:
Do not put giue around part A in Fig. 26.
Soldering Iron
t
Motor Pulley
Motor
Figure 25.
A Little Metal Glue~
Gap
\
Motor Pulley
yo
Imm T
(A)
" Keeping for
1 minute.
Motor
Figure
26.
Advertisement
