Mitsubishi Electric MC-8000 Service Manual page 5

| MC-8000
DISASSEMBLY INSTRUCTIONS ..... Tuner & Amplifier Section
1. Removal of Rear Cover (Refer to Fig. 1.)
1) Remove the 14 screws (1) (black bind head tapping
screw, 3 x 16).
2) Remove the screw (2) (black bind head tapping screw,
3x 16). aa
3) Unscrew the two screws @) (black bind head, M3 x 8)
and shake proof washer on the threaded section to the
right.
4) Remove the screw (4) (black bind head tapping screw,
3x 10).
5) Remove the four screws &) (black bind head tapping
screw, 4 x 10).
6) When the two screws @) (black bind head tapping
screw, 3 x 12) are removed, the power switch c. board
and knob will come off. | i>®
7) Pull out the lead connectors from the transformer |. Bottom side
(Fig. 2) at 7 points. ||| rear cover
Amp P.C.B Deck P.C.B
-* ® Connector P.C.B Fig. 1
Connectors saisiasidacciauinal
| tt 8 j901—=0
Red leads Ss
=
Sa
a Orange
Black leads
; leads te Green leads
§ Sf
Bottom
Bottom
plate plate
\ cannot be can be
removed
removed
NOTE: For reinstallation the
lead in pairs shoud be
push into the terminals
after braiding them
together for at least 7 times
Power transformer
Fig. 2
2. Drawing Out Lower-section Body
1) With the body laying on its side, remove the six screws
(yellow bind head, M4 x 16) and six washers shown in
Fig. 3. (For sets with serial numbers from No, 801
onward, the four screws (1) and washers shown in a a
Fig. 4 are to be removed.)
2) Unscrew the six screws (yellow bind head tapping
screw, 4 x 10) and washers located inside the cabinet.
(Refer to Fig. 5.)