Advertisement
Available languages
Available languages
1) After pulling out the VOLUME, BALANCE, BASS and
TREBLE
knobs, take off the nuts used for fixing the
shafts.
5. Removal
of Bottom
Plate (Only for sets with serial
numbers from #801 onward).
board from the bottom side.)
|
MIC-8000
DISASSEMBLY
INSTRUCTION
Cassette Deck Section
1. Removal
of Cassette Deck C. Board and Mechanism
Ass'y
The Cassette Deck C. Board and mechanism ass'y can be
removed in the condition with the mechanism mounted on
the c. board.
1) Following
the Disassembly
Instructions
for the Tuner
and Amplifier Section, take off the rear cover and draw
out the lower-section body toward the front.
2) Take off the cassette cover.
3) After pulling out the REC LEVEL and MIXING knobs,
remove the nut fixing the variable resistors (VRs).
4) Using a nipper, or the like, cut off the wire clamper
fixing the wiring leading out from
the panel section.
Also disconnect
the plugs connected to the Cassette
Deck C. Board.
NOTE:
When reinstalling, arrange the wiring neatly and
fix it to its former position using the wire
clamper.
5) Remove
the four screws
(yellow bind
head, 3 x 12)
shown
in Fig. 1 used for fixing
the mechanism ass'y.
6) Remove the two screws (black bind head, tapped, 3 x 8)
shown in Fig. 2.
7) Disengage the belt on the tape counter.
8) The
circuit
board
and
mechanism
ass'y can
be dis-
mounted
in this condition.
The
mechanism
ass'y
is
secured by bending the pawis which are inserted into
the circuit
board.
To
take off the mechanism
ass'y,
unbend these pawls first, using a pair of pliers.
Remove four screws
Belt for counter
C. board
Remove two black screw
Fig. 2
Advertisement
