Advertisement
Available languages
Available languages
2 Operation
2.3 Assembling/operating your garment steamer
1. Grab the handle of the water tank, pull out the tank, open the water inlet
cover and fill the tap water into the tank. Make sure the tank is at least
two-thirds full and does not exceed the maximum water level. Then return
to the tank and hear two clicks to indicate that the installation is in place.
2. Hold the steam brush head of the hanging ironing machine by hand, and
install the additional brush on the steam head with the other hand. It clicks
when installed in the correct position.
3. Connect the device to a power outlet and switch on the power. Turn the
gear knob to each gear, the power indicator light will be on, hanging ironing
machine to start heating. After the preheating is finished, the steam head
will steam out automatically and you can start using it. When the gear knob
is turned to close, the indicator light will go out.
• Do not exceed the MAXIMUM level when filling the water
tank.
• Press the power button (6), the display screen icons will
blink for once, and then only the steam level icon will blink
indicating that the device is heating up. Allow the device to
preheat before use. The device is ready for use when the
C
steam icon is lit continuously.
• You may switch between steam levels by pressing the
power button.
• The garment steamer has an intelligent automatic power
off function. When the user stops operating this product
for more than 8 minutes of time, the internal control
circuit will cut off power supply, and the product will enter
standby mode to ensure safety and to save energy. At the
same time, the "auto shut off indicator" blinks.
C
When there is not enough water in the tank, the pump will
automatically stop working within 25-35 seconds (Noise is
normal during this process). Finally, "No water in the tank"
icon blinks.
Vertical Garment Steamer / User Manual
17 / EN
Advertisement
