Siemens TELEPRINTER 100 Operating Instructions Manual page 14

If your teleprinter is installed in afloor cabinet, the paper supply roll is
replaced in the same way as just described for the teleprinter with protec¬
tive cover. The paper deflecting bail shown in Fig. 1is here omitted and,
for opening the lid, it is not necessary to depress the two rectangular plates
(shown in Fig. 2). Simply lift the lid.
T h e l o c k i n g a r m s s h o w n i n F i g . 4 c a n a l s o b e d i s p e n s e d w i t h b e c a u s e t h e
paper roll support differs slightly from that employed with the protective
c o v e r v e r s i o n .
Replacing the ink ribbon (observe para. 6)
6 . 2 .
O p e n t h e l i d . G r a s p t h e p a p e r
s a d d l e f r o m b e l o w w i t h o n e
finger and force it upwards un¬
til it unlatches. The paper saddle
remains in this position and the
t w o i n k r i b b o n s p o o l s c a n b e
pulled off their shafts after re¬
leasing the retainers.
Detach ink ribbon from the guides
a n d r i b b o n l i f t e r . A t t a c h t h e b e ¬
g i n n i n g o f t h e n e w r i b b o n t o
the emply reel (as on an office
t y p e w r i t e r ) a n d p l a c e b o t h
s p o o l s o n t h e i r s h a f t s s o t h a t
they engage in the driver pins.
Secure spools with the retainers,
a n d i n s e r t i n k r i b b o n b e t w e e n
the guides and through the rib¬
bon lifter as shown in the photo¬
g r a p h .
D e p r e s s t h e p a p e r s a d d l e w i t h
one finger until it latches, close
t h e l i d , a n d s w i n g p a p e r d e ¬
flecting bail to the front.
1 1