Siemens TELEPRINTER 100 Operating Instructions Manual page 22

11. Teleprinter 100 with two-color printing attachment
All paragraphs contained in this instruction book appiy also to the tele¬
printer with two-color printing attachment. Make sure that the black side is
always on top when replacing the ink ribbon.
12. Teleprinter 100 with reperforator attachment, tapetransmitter
attachment and remote control unit type "NL
/ /
The paragraphs 1through 11 also apply to this version.
12.1. Preparing aperforated tape
If you want to punch amessage into atape, depress the key marked with
agreen ring on your remote controi unit. This causes the motor of your
teleprinter to start up; the lamps in the ciearing key and the off-iine key
on the remote controi unit iight up. Start your reperforator by depressing
pushbutton A f t e r s t r i k i n g k e y " A . . . " t w o o r t h r e e t i m e s , y o u m a y
begin punching.
With the message punched into the tape, switch off the reperforator by de¬
pressing pushbutton "0". Then switch off the motor of your teieprinter by
depressing the clearing key in the remote control unit. With pushbutton L
(on reperforator attachment) held depressed, pull the perforated tape out
t o t h e f r o n t a n d t e a r i t o f f .
Should acall arrive over the exchange line while you are punching the
tape, abuzzer will sound in the remote control unit. In this case the push¬
button "0" of the reperforator attachment must be actuated within three
seconds. This permits the incoming message to be received without spoiling
the signals previously punched into the tape. When the message has been
received, depress the key with the green ring on the remote control unit
again. When the motor has started up again and the lamps in the clearing
key and the off-line key are lit, you may continue to prepare the perforated
tape after switching on the reperforator attachment by depressing push¬
button "O" and after depressing the keys "<",
"1 ..." if you had been interrupted while typing afigure or asymbol).
// n
a n d " A . . . " ( o r
12.2. Backspacing the tape to correct errors
The tape can be returned by one character space each time the key Rof
the reperforator attachment is depressed. Be careful that the key is com¬
p l e t e l y d e p r e s s e d e a c h t i m e .
1 9