Table of Contents
Advertisement
Brief excerpt of the INSTRUCTION FOR USE
2-10
WARNING -
'Under no circumstances should you ty
'to repair the set yourself, as this will.
-invalidate. the guarantee.
;
ee
below before taking the set for repair.
Ifa fault occurs, first check the points listed
English
'If you are unable to remedy a problem by
~~ following these hints, consult your dealer or
service center.
PROBLEM
No sound / no power
No reaction to
operation of any keys
Poor radio reception
nod
of
or
Errear indication
The CD skips tracks
Poor cassette sound
quality
Recording does not
work
Remote control does
not function properly
POSSIBLE CAUSE
VOLUME is not adjusted
REMEDY
Adjust the VOLUME
Headphone is connected
Mains cable is not securely connected
Disconnect headphone
Connect the mains cable properly
Batteries are flat
Replace batteries
Batteries are incorrectly inserted
Insert the batteries correctly
Changing over from mains to battery
supply without removing the plug
Electrostatic discharge
Weak radio aerial signal
Interference caused by the vicinity of
electrical equipment like TVs, video
recorders, computers, engines, etc.
The CD is badly scratched or dirty
Pull out the mains plug from the
unit's AC MAINS inlet
Disconnect the set from power supply
reconnect it after a few seconds
Aim the aerial for optimum reception:
— FM/SW: incline and rotate telescopic
antenna
— AM/MW/|W: rotate the entire set
Keep the radio away from electrical
equipment
Replace or clean the CD, see maintenance
No CD is inserted
The CD is inserted upside down
Insert a CD
Insert a CD with label upwards
The laser lens is steamed up
The CD is damaged or dirty
Wait until the lens has cleared
Replace or clean the CD
SHUFFLE Of PROGRAM is active
Switch off shuffle or program play
Dust and dirt on the heads, capstan
or pressure roller
Clean the heads, capstan and pressure
roller, see MAINTENANCE
Use of unsuitable cassette types
(METAL or CHROME)
Cassette tab(s) may be snapped off
Batteries are incorrectly inserted
Only use NORMAL cassettes for
recording
Apply a piece of adhesive tape over
the missing tab space
Insert the batteries correctly
Batteries are flat
Distance to the set is too large
Replace batteries
Reduce the distance
CS 48 879
Advertisement
Table of Contents
