Table of Contents
Advertisement
GZ8
8b SO
=e
Tuning
1 Select the tuner by pressing the CD-TAPE-TUNER button
several times until
appears on the display.
2 Select the wave band by using the BAND selector.
~» Display indication: the selected waveband.
3 Press TUNING i« or >» for approx. one second and then release
the button,
~» The radio automatically tunes to a station with sufficient
= [
strength. Display indication during automatic tuning: Srch
|
ay
fp
Li
4 Repeat this procedure until you find a station you desire.
aoe
5 ren
:
To tune to a weak transmitter briefly press TUNING << or p> as
often as necessary for optimum reception, or until the correct
frequency is indicated in the display.
Improving RADIO reception
For FM and SW (SW waveband is not applicable on all versions.)
pull out the telescopic antenna. To improve the signal, incline and
turn the antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
For AM, MW and LW, direct the built-in antenna by turning the
whole set. The telescopic antenna is not needed.
Switchable tuning grid (not on all versions)
In some versions the frequency steps can be changed. Usually the
frequency step for your area has been preset in the factory.
Keep the BAND selector button pressed for more than 5 seconds.
-» The display shows either (2 Gr dord
Gr d.
~} tuning to a preset station, the preset number (1 to 29) is indicated
iPr
You can store up to 29 radio stations in the memory. When
in the display.
1 Select the tuner by pressing the CD-TAPE-TUNER button several
times until
appears on the display.
2 Tune to a desired station with TUNING i or >», as described
earlier.
—» If the frequency is already stored in the memory, the preset
number will be displayed.
3 Press PROGRAM to enter the programming mode.
—» During programming, preGRAM flashes on the display.
4 Press PRESET 4 or to allocate a number from 1 to 29 to the
preset station.
5 Press PROGRAM to confirm the setting.
Tuning to preset stations
Press PRESET 4 or > until the desired preset number appears on the
display.
Environmental information
All redundant packing material has been omitted. We have done our outmost to make the
packaging easy seperable into three mono materials: cardboard {box), polystyrene foam (buffer)
and polyethylene (bags, protective foam sheet).
Your set consists of material which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packing materials, exhausted
batteries and old equipment.
ASN
YO
NOLLONYLSNI
284}
Jo }duaoxe
Jorg
9-¢
Advertisement
Table of Contents
