Location Of Controls - Panasonic KX-G8300 Service Manual And Technical Manual

LO Get Kitt)
LOCATION OF CONTROLS
@Power ON/OFF Button
Used to turn ON the power source. Press this and TX/STBY button
simultaneously to turn off the unit.
@®Transmit/Standby (Power Saving Mode) Button
Switches between Transmit/Standby modes. /Set the Power Saving Mode.
@Saving Mode Indicator
This indicator lights in green when the system is in the Power Saving Mode.
@EBL/VRM Position Button
Used to measure the distance and bearing when the target is focused on by
turning EBL counter clockwise and reduction VRM.
©®EBL1/EBL2 ON/OFF Button
Turns ON/OFF EBL1 and EBL2.
©VRM Shift ON/OFF Button
Displays a third VRM on the screen to measure the distance between two
targets.
@Fixed Range Ring Display (Plot) Button
Displays/removes the fixed range rings./Displays sequential tracks of other
vessels.
®©@Anti Clutter Rain (Interference Rejection) Button
Eliminates rain clutter reflection from the screen./Turns on and off the
interference rejection (IR) mode when pressed after the FUNC button.
@Memory Display (Memory Storage) Button
Memorizes the current display or erases the memory./Recalls or eliminates
the memorized display to or from the screen.
Heading Marker Off (EBL & VRM Clear) Button
Temporarily removes the heading marker from the screen./Deletes EBL and
VRM.
@ Range (Down) Button
Reduces the range of measurement.
@ Receiver Tuning Control Knob
Adjusts the receiver sensitivity to the transmitter.
® Anti Clutter Sea Control Knob
Eliminates the unwanted echoes from the near by sea surface.
Receiver Gain Control Knob
Adjusts the receiver gain.
@EBL/VRM Position Button
Used to measure the distance and bearing by sighting the target with the
clockwise turn of EBL and the enlargement of VRM.
@ VRM1/VRM2 ON/OFF Button
Turns ON/OFF VRM1 and VRN2.
@ Off Center Button
Shifts the position of your own vessel 50% backward from the bearing
indicated by EBL. This enables the user to observe a target located farther
away.
@ Guard Zone Alarm (Display Freeze) Button
Sets or eliminates an alarm zone. When an alarm zone is set, the entry of an
terget is informed with an alarm./Temporarily stops the display motion.
@ Display Brilliance Control (Panel Illumination Dimmer) Button
Adjusts the display brilliance./Adjusts the illumination of the control panel
when pressed after the FUNC button.
@ Target Expansion (Navigation Data Display) Button
Used for target expansion./When Loran is installed, pressing the FUNC
button and this displays the longitude and latitude of own position range and
bearing to a waypoint.
@ Function Button
Allows the user to select a function shown in blue reversed print on buttons,
@)@. ©. ©. @,. @ ®, and@.
@ Range (Up) Button
Expands the range of measurement.
Main Unit
(Display and Main Contoler)
Fig. 2