Page 1
Koninklijke Philips Electronics N.V. or their respective owners. TP Vision Netherlands B.V. reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. PHILIPS and the PHILIPS’ Shield Emblem are used under license from Koninklijke Philips Electronics N.V.
3. M ec hani c al Instr uc ti ons ………………… .…………………………………………………………………… . 6 Cable dressing (32" 32PHT4012/05)………………………………………………………………………………6 A s s e m b l y / P a n e l R e m o v a l … … … … … … … … … … … … … … … … … … … … … … … … … … … … … 6 4.
1. Product information Product information is subject to change without notice. For detailed product information,please visit www.philips.com/support Display Type Diagonal screen size •32PHT4012/05: 32inch Display resolution •1920*1080p Input resolution • 800 x 600p - 60 Hz • 1024 x 768p - 60 Hz •...
Page 4
Picture Playback Formats JPEG、BMP、PNG Power Product specifications are subject to change without notice. For more specification details of this product, see www.philips.com/support Power • Mains power : AC 111-212V 50/60Hz • Standby Energy Consumption:≤0.5W • Ambient temperature : 5°C to 40°C...
CN3 to T-CON board Speaker wire CAN1 to speaker (yellow black wire) Speaker wire CAN3 to speaker (red black wire) For(32”32PHT4012/05) 3.2 Assembly/Panel Removal 3.2.1 Stand removal 1. Remove the fixation screws [1] 4pcs ,that secure the stand 2. Take the stand bracket out from the set.
Page 7
3.2.2 IR board &key board 1. Unplug the connector from the SSB. Caution: be careful, as these are very fragile connectors! 2. Remove all the fixation screws(5) ,from the IR board control unit. then Remove the fixation screws(6), the IR board control unit. When defective, replace the whole unit 3.2.3 Rear Cover Warning: Disconnect the mains power cord before removing the rear cover.
Page 8
3.2.5 Speakers 1. Gently release the tapes that secure the speaker cables. 2. Unplug the speaker connector from the SSB. Take the speakers out. When defective, replace the both units. 3.2. LCD Panel 3. Remove the SSB as described earlier. 2.
Software upgrading and Panel Code Software Upgrading Operations and procedure of software upgrading: 1). Changed the file name to "MERGE.bin", then stored software in the FA T32 format blank U disk. 2). Insert USB flash disk into the USB upgrade port, upgrade the software according to the following the operating instructions: Select AIR or DTV signal source, press Menu key to pop up the main menu, then choose.
Page 12
Press the following key sequence on a standard RC transmitter: “1999” directly followed by MENU, can see the panel type information from factory menu, see the Panel PN from the configuration table CTN_ALT BOM# Panel Type Panel PN 32PHT4012/05 K320WDK3B-LW330A2 7422320LGK3AK011-F...
6.1 Introduction The 4012 is covered by MSD3463 platform. The major deltas versus its predecessor support DVB-T, with also multi-media, Video out The MSD3463 chassis comes with the following stylings: Series 4012 32PHT4012/05 6.1.1 Implementation Key components of this chassis are: TUNER POWER AS1117 ...
Page 14
Always replace a defective fuse with one with the correct specifications! This part is available in the regular market. Consult the Philips Service web portal for the order codes of the boards. Important delta’s with the platform are: •...
Page 15
• +12V, input from the power supply for LNB supply • +3V3-FLASH, voltage for FLASH when TV on • +3.3VA_T2, +1.2V_T2 voltage for Demodulator IC channel decoder • TUNER_3V3, supply voltage for tuner • +5V-SW, input intermediate supply voltage for USB Power •...
Page 16
UD1 Change 12V to 5V FU1 5V for USB R117 5V for Optical UT2 3.3V for Tuner For(32” 32PHT4012/05) 6.4 Front-End Analogue and DVB-C, DVB-T; reception 6.4.1 DVB-C part The Front-End for analogue tuner consist of the following key components: •...
Page 17
• SCALER MSD3463 Below find a block diagram of the front-end application for DTV part. EARDATEK 6.5 HDMI Refer to below for the application. The following HDMI connector can be used: • HDMI 1: HDMI input ( TV digital interface support HDCP •...
Page 18
6.6 Video and Audio Processing - MSD3463 The MSD3463 is the main audio and video processor (or System-on-Chip) for this platform. It has the following features: 1. Worldwide multi-standard analog TV demodulator 2.PAL/SECAM/DVB-T/DVB-T2 /DVB-C demodulators 3.1920*1080@60Hz direct drive 4. Powerful CPU core 5.