Factory Selected Components; Adjustment Locations - HP 5315 A Operating And Service Manual

Model 5315A / S
Adjustments
SECTION V
ADJUSTMENTS
5-1. INTRODUCTION
5-2_ This section describes the adjustme nts required to maintain the 5315A1B operating
characteristics within specifications_ Adjustments shou ld be made when required, such as after a
performance test failure or when co mponents are replaced that may affect an adjustment
5-3. Table
5-1 is a li st of all adju sta ble components in the
5315A / B
and indicates the order in
which adjustments should be performed.
5-4. EQUIPMENT REQUIRED
5-5. The test equipment required for the ad just ment procedures is listed in
Table
5-1, Recom-
mended Test Equipment. Substitute inst ruments may be used if they meet the critical
specifications.
5-6. FACTORY SELECTED COMPONENTS
5-7. Th e re are no factory selected components in the standa rd 5315A/ B.
5-8. ADJUSTMENT LOCATIONS
5-9. Figures 5-1,5-2, and 5-3 illu st rate the location of all adjustments and test points used in the
5315A /S adjustment procedures.
WARNING
MAINTENANCE DESCRIBED HEREIN IS PERFORMED WITH
POWER SUPPLIED TO THE INSTRUMENT, AND PROTECTIVE
COVERS REMOVED. SUCH MAINTENANCE SHOULD BE PER-
FORMED ONLY BY SERVICE-TRAINED PERSONNEL WHO ARE
AWARE OF THE HAZARDS INVOLVED (FOR EXAMPLE, FIRE
AND ELECTRICAL SHOCK). WHERE MAINTENANCE CAN BE
PERFORMED WITHOUT POWER APPLIED, THE POWER
SHOULD BE REMOVED.
BEFORE ANY REPAIR IS COMPLETED, ENSURE THAT ALL
SAFETY FEATURES ARE INTACT AND FUNCTIONING, AND
THAT ALL NECESSARY PARTS ARE CONNECTED TO THEIR
PROTECTIVE GROUNDING MEANS.
5-1