Setup; Installing The Handle - Toro 23521 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Installing the Handle

Parts needed for this procedure:
1 Cable tie
4 Handle bolt
4 Nut (5/16 inch)
2 Slotted-head bolt (#10)
2 Locknut (#10)
Procedure
1. Install the upper handle tubes to the lower
handle and braces using 2 handle bolts and 2
nuts (5/16 inch) on both sides of the machine
(Figure 3).
Description
Cable tie
Handle bolt
Nut (5/16 inch)
Slotted-head bolt (#10)
Locknut (#10)
No parts required
Qty.
1
4
4 Install the handle.
2
2
–
Connect the negative battery cable.
1. Upper handle tube
2. Handle bolt
3. Lower handle
2. Secure the throttle cable over the lower handle
using a cable tie
6
Use
Figure 3
Left side shown
4. Nut (5/16 inch)
5. Brace
(Figure 4).
g194930