Craftsman CMXGTAMD25CC Operator's Manual page 10

Electric start capable 2-cycle gas trimmers
Table of Contents

Advertisement

Available languages

Available languages

INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Push the handle down onto the upper shaft housing (Fig. 8).
Make sure the bolt hole faces to the right (Fig. 8).
2. Insert the bolt into the bolt hole and push it through (Fig. 8).
Tighten the bolt with a flat-head screwdriver, but do not tighten
the bolt completely .
3. Hold the unit in the operating position (Fig. 13). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 8). Make sure the handle is positioned beyond the end of the
safety label (Fig. 8).
4. Tighten the bolt with a flat-head screwdriver until the handle is
secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolt with a flat-head screwdriver (Fig. 8).
2. Hold the unit in the operating position (Fig. 13). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 8). Make sure the handle is positioned beyond the end of the
safety label (Fig. 8).
3. Tighten the bolt with a flat-head screwdriver until the handle is
secure.
Safety Label
Bolt Hole
Bolt
10
Handle
Upper Shaft
Housing
Fig. 8

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Cmxgtamd25sc

Table of Contents