Husqvarna PG 400 Operator's Manual page 15

2. Keep the tool plate against the surface. Make sure
that the tool plate does not rotate before you lift up
the front.
3. Pull out the power plug.
To replace the diamond tools
WARNING:
WARNING:
very hot. Use protective gloves.
1. Set the ON/OFF switch to 0 and disconnect the
power plug to stop the product. Refer to
product on page 14 .
2. Put the product in servicing position.
CAUTION:
the servicing position on a horizontal
surface.
3. Use a hammer to remove the diamond tools.
2258 - 002 - 25.10.2023
Disconnect the power plug.
Diamond tools can become
To stop the
Only put the product in
4. Attach new diamond tools on the tool plate.
5. Put the product in operation position.
To connect a dust extractor
Use a Husqvarna dust extractor system.
15