HP 30242 Installation And Service Manual page 55

_CO_N_F_IG_U_R_A_T_IO_N_IN_F_O_RM_A T_I_O_N_ _
-----'I~
This appendix describes how to configure MPE to include the LAN/3000 link.
The MPE configuration must be modified when a LANIC card is added to the computer system. Before
configuring MPE, install the LANIC card as described in Section 2.
CONFIGURA TION DIALOG
The following configuration dialog deals only with configuring a LANIC card into the system. The
complete configuration dialog is contained in the
HP 3000 System Operation and Resource Management
Reference Manual, part number 32033-90005.
To begin the configuration dialog, log onto the system as MANAGER. SYS, define the output files as
sho\vn below, and initiate a SYSDUMP as outlined in the following steps.
NOTE
Where necessary to distinguish user input from computer output, the user
input is underlined. The IIStep No. 1I in the dialogue below corresponds to
the IIStep Number ll in the dialogue contained in the
HP 3000 System
Operation and Resource Management Reference Manual, part number
32033-90005.
It is essential that the LANIC driver, IOLANO. PUB. SYS be present when
the UPDATE or COLDSTART or RELOAD is done. You may verify that
the driver is present by typing:
:LISTF IOLANO.PUB.SYS
Define the output files and initiate SYSDUMP as follows:
:HELLO MANAGER.SYS
:FILE T;DEV=TAPE
:FILE L;DEV=LP
:SYSDUMP *T,*L
Feb 85
A-I