Table of Contents
Advertisement
mm CHAPTER 3 MECHANICAL SYSTEM
1. Removing the Roll Media Feed
Guide Unit
1)
Remove the left and right covers.
2)
Open the roll media cover.
3)
Remove the roll shaft.
4)
Remove the control panel. (See page 3-6.)
5)
Remove the pre-discharge and waste ink tanks.
(See page 3-26.)
S
6) Remove mounting screws © (2 each on left
and right), and remove roll shaft holders @ (on
both left and right).
Figure 3-403
10) Remove the media retainer unit and media
retainer solenoid. (See page 3-18.)
11) Disconnect the connector (8) and remove the
stepped screw ©).
Remove the mounting screw @0 to remove
switch mounting plate ©.
Remove a screw (2.
Figure 3-401
7)
Remove the roll media cover. (See page 3-4.)
8)
Disconnect connector @, remove 3 mounting
;
screws @), and remove path change motor unit
Figure 3-404
Figure 3-402
Advertisement
Table of Contents
