Installing The Prescription Lens Frame - Lenovo Legion User Manual

Adjusting the Nose Pad
After putting on the glasses, you should keep the image in the center of your vision and be able to
see it in its entirety. The three types of nose pads can be adjusted flexibly. Select a nose pad and
adjust it to better fit the nose. If the image is incomplete, try to replace or adjust the nose pad.
Adjusting the nose pad will affect the view of the image in the glasses, refer to
Wearing Position to Optimize the Visual Experience
Adjust the nose pad as follows:
After putting on the glasses, if you feel stress at a certain point of the nose bridge,
or pain and discomfort occur after prolonged use, it may be caused by a mismatch
between the shape of the nose pad and the nose bridge. Adjust the opening angle of
the nose pad and the rotation angle of the two wings of the nose pad immediately
according to the wearing experience.
Installing the Nose Pad
To install the nose pad, insert it into the slot completely in the direction shown below. To replace
the nose pad, pull out the nose pad in the opposite direction and remove the original nose pad.

2.4 Installing the Prescription Lens Frame

After the customized lenses are ready, ensure that the nose pad has been installed on the glasses,
and then install the frame as shown below.
The two wings of the nose pad can be adjusted inward or outward
according to the width of the nose bridge. The larger the opening
angle, the lower the wearing position of the glasses. Bend the
ends of the two wings of the nose pad slightly to fit different nose
shapes.
The two wings of the nose pad can also be rotated to a certain
angle to fit the sides of your nose bridge to reduce the pressure of
the glasses on the nose.
Insert the slot in the middle of the glasses to install the nose pad
in the User Guide.
- 4 -
2.6 Adjusting the