Sharp QA-1200 Operation Manual page 12

2) Connecting the Macintosh II Signal Cable to an Apple® Macintosh II
The Macintosh II signal cable has a 15-pin male connector on one end and a 26-pin HD male connector on the
other end.
Plug the 15-pin connector into the 15-pin monitor output connector on the computer.
Use a screwdriver to fasten the connectors securely together.
HULL
z'
@
Apple® Macintosh II computer
Macintosh II signal cable
Plug the 26-pin connector end of the Macintosh II cable to the COMPUTER IN connector on the projection
panel.
Use a screwdriver to fasten the connectors securely together.
COMPUTER IN
Macintosh II signal cable
3) Connecting to Macintosh Computer
Because the Macintosh computers do not have a video connector, you must install an optional internal adaptor.
The Macintosh, 512, Plus, SE, SE/30 and Classic require these adaptors. These are available from your local
Authorized Sharp dealer.
10