Table of Contents
Advertisement
6) Video input connection
Connect the video signal cable to the composite video input connector. Then press the I (INPUT) button on the
remote control to switch between PC and video input on the projection panel.
This unit supports NTSC, PAL and SECAM
video standards, and detects the type from the input signal,
switching automatically.
The video adjustments are preset at the factory. Adjustments can be made by using the A/V Adjust Menu built
into the panel. For A/V adjustments please refer to page 18.
Video in (RCA)
Composite video signal cable
|
To video source
NOTES
To display NTSC, PAL, or SECAM on the projection panel, the video signal must meet the following
requirements. (If not, improper display will be obtained.)
(1) It must be a composite video signal complying with system M (NTSC), systems B, G, H and I (PAL),
or system B, G, H, D, K and L(SECAM).
(2) The signal level must be 1.0 V peak-to-peak.
(3) The output impedance must be 75 Q.
When video input of PAL or SECAM signals from sources such as VCR tape are not received properly,
switch from the Auto mode to the fixed PAL or SECAM mode in the Display Mode menu. (See page 19.)
7) External monitor connection
Connect your computer monitor to the external monitor output connector, to simultaneously view images on
the external monitor and projection panel.
External VGA monitor
External Macintosh monitor
12
Advertisement
Table of Contents
