DR-E34BK
DR-E34LBK
Fig. 8
Abb. 8
Afb. 8
€ Fig. 7, Fig. 8
How to connect cords (Fig. 9)
¢
How to connect the FM connector
Open antenna terminal tevers.
In case of a 75-ohm antenna (Fig. 7)
Plug cords into the terminals.
1. Open the claws at both sides and remove the
& .
Close the levers.
(@)(N)()
cover.
BEAT CUT knob (Fig. 10)
2. Cut both ends of the cord and remove it. (only
When recording an AM (MW/LW) broadcast. beats
when using coaxial cabie)
may occur.
3. Fix the coaxial cable and its core.
Set the BEAT CUT knob located on the rear panel
4. Put on the cover.
to "1" or 2" so beats will be eliminated.
In case of a 300-ohm antenna (Fig. 8)
Itis not necessary to remove the cover. if the wire
inside is cut, 300 ohm antenna can not be used.
Notes:
*
Choose antennas to meet the reception
conditions.
*
Orient
and
fix antennas
where
audio
reception is the clearest.
Fig. 9
| Fig. 10
Abb. 9
| Abb. 10
_ Afb. 9
Afb. 10
(No. 20162) 1-5