Toro 135-6822 Installation Instructions Manual page 12

2. Remove the screw (5/16 x 3/4 inch) that secures
the bushing to the transmission housing, and
remove the bushing
1. Screw (5/16 x 1 inch)
2. Lower bidirectional arm
3. Upper bidirectional arm
4. Screw (5/16 x 3/4 inch)
3. Remove the spring from the upper and lower
bidirectional arms
4. Remove the screw (5/16 x 1 inch) that secures
the upper and lower bidirectional arms, and
return-control arm to the transmission housing,
and remove the arms
Note:
Discard the upper and lower bidirectional
arms.
Installing the Upper and Lower
Return Arm and the Neutral Arm
1. Assemble the upper return arm, lower return
arm, return-control arm, and neutral arm and
reverse switch to the transmission housing with
the torx-head screw as shown in
(Figure 26).
Figure 26
5. Bushing
6. Washer
7. Spring
8. Return-control arm
(Figure 26).
(Figure 26).
Figure
g289451
1. Torx-head screw
2. Lower return arm
3. Upper return arm
4. Screw (5/16 x 3/4 inch)
2. Install the screw (5/16 x 3/4 inch) and bushing to
the transmission housing as shown in
3. Assemble the transaxle bracket onto the return
control arm with the carriage bolt and flange
locknut
27.
1. Flange locknut
2. Transaxle bracket
4. Assemble the spring onto the hooks of the upper
and lower return arms
12
Figure 27
5. Bushing
6. Return-control arm
7. Neutral arm and reverse
switch
(Figure 28).
Figure 28
3. Return control arm
4. Carriage bolt
(Figure
g289442
Figure 27.
g289444
29).