Sony SLV-595HF Service Manual page 2

Wirel
less Commander RMT-V1020 (for SLV-59SHF)/
V112A (for SLV-696HF)
Remote control system _ Infrared control
Command mode
Power requirements
VTR 1/2/83 switchable
3V DC, 2 size AA batteries
(IEC designation R6)
| Accessories Supplied |
Wireless Commander RMT-V102D
(for SLV-595HF)/V112A (for SLV-696HF) (1)
Size AA (R6) batteries ES (2)
75-ohm coaxial cable with F-type connectors (1)
External antenna connector . . a)
'AC power cord B a s i e i e chen Utes
Audio/video connecting cable (3 phono to 3 phono) . .
Design and specifications are subject to change without
notice.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer:
1. Check the area of your repair for unsoldered or
poorly-soldered connections. Check the entire
board surface for solder splashes and bridges.
2. Check the interboard wiring to ensure that no
wires are "pinched" or contact high-wattage
resistors,
3. Look for unauthorized replacement parts, par-
ticularly transistors, that were installed during a
previous repair. Point them out to the customer
and recommend their replacement.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK /\ OR DOTTED
LINE WITH MARK /\ ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
4.
Look for parts which, though functioning, show
obvious signs of deterioration. Point them out
to the customer and recommend their replace-
ment.
Check the B+ voltage to see it is at the values
specified.
ATTENTION AU COMPOSANT AYANT RAPPORT
A LA SECURITE!
LES COMPOSANTS IDENTIFIES PAR UNE MARQUE /}\
SUR LES DIAGRAMMES SCHEMATIQUES ET LA LISTE
DES PIECES SONT CRITIQUES POUR LA SECURITE
DE FONCTIONNEMENT. NE REMPLACER CES COM-
POSANTS QUE PAR DES PIECES SONY DONT LES
NUMEROS SONT DONNES DANS CE MANUEL OU
DANS LES SUPPLEMENTS PUBLIES PAR SONY.