Table of Contents
Advertisement
CARE OF UNIT
Do not allow any foreign matter to enter the
Never use volatile liquids such as thinner or
interior of the typewriter or get between the
benzine to clean the exterior surface of the
keys. Be especially careful of metal objects
typewriter. Use only a soft cloth dampened
Such as paper clips and staples.
with a mild detergent solution.
Do not locate your typewriter
Do not block the ventilation slits
| When the typewriter is not in use,
where it is exposed to direct
provided in the back of the unit to | be sure to replace the keyboard
sunlight, heat or intense vibration. | protect against the danger of
cover.
overheating.
TROUBLESHOOTING
If any operational difficulty arises, check below. If the trouble can not be overcome by
following these instructions, then consult your Brother dealer.
Typewriter remains at a standstill with the
(1) Make sure the power cord is plugged in.
on-off switch set at ON.
(2) Be sure the top cover is closed.
(1) Be sure daisy wheel is properly set.
Printing is faint or does not appear.
(2) Check positioning of cassette ribbon.
(3) Check to see that the ribbon has not been fully used.
(1) Be sure the correction tape is properly set and passed
through the tape guides.
Correction cannot be made.
(2) Check to see that the correction tape has not been fully used.
(3) Be sure the correction tape has been properly selected to
match the cassette ribbon.
Cassette ribbon lifts up and remains up
Turn the power off first. Then turn it on again while holding down
(this rarely happens).
the code key and the pitch selector.
Advertisement
Table of Contents
