Mitsubishi Electric 800 Series Instruction Manual page 18

2 . System Configuration MELSEC GOT
2.2.2 System Configuration Precaution Items
a
Power Supply Module handling and installation method
Refer to the GOT User's Manual.
Power wire, ground wire, FD mesh wire connection method
@
Connect the power supply wires and ground wires as shown in the diagram below,
and when they are within 100mm (3.94 inch) from the Power Supply Module's termi-
nal block, be sure to install the ferrite core (ZCAT3035-1330 made by TDK) supplied
in the package in the Power Supply Module.
@
When grounding a ground wire in the control panel then ground it in the same posi-
tion as the LG wire and the shield mesh.
@
To prevent radiated noise when configuring a GOT with a Power Supply Module,
install the FG mesh wire included in the packaging with the Power Supply Module to
the Power Supply Module FG terminal and then attach it to the screw holes on the
bottom of the EMC Box.
EMC Box
' 0 0 0 '
0
0
Power Supply Module
FG mesh wire ground area
\O
0 0,
2 - 9