Table of Contents
Advertisement
UNDEFINED
SYMBOLS
MULTIPLE
SYMBOLS
NO REFERENCE
XXX ERRORS
TAPE 3
XXX ERRORS
TAPE 4
c.
Press
A~I
button.
d.
Place processor in AUTO mode and depress START.
A
symbol or symbols were referenced but were not defined.
A
multiply-defined symbol in the symbol or operand fields.
No reference was made to the symbols following this message.
If
tape 3 is used for comments, this typeout signifies the
number of bad spots on tape 3. (Switch 3 in normal position.)
Signifies the number of bad spots on tape 4. (Switch 4 in
normal position.)
6.
Action required for all other stops:
a.
Place processor in MANUAL mode.
b.
Check the CARD PUNCH READY indicator.
If
punch is not in ready status, place
in ready status and depress START.
c.
Check the N-REGISTER READY light.
If
not in ready status, manually type spaces
until N-register becomes ready and depress START.
If
the CARD READER alarm
indicator is on, check the card deck for damaged cards. Replace if necessary and
reload the program from the beginning.
OUTPUT FROM GENERAL ASSEMBLY PROGRAM PASS 0
The output from pass 0 is shown below:
Front of Deck
~ Symbol Table 1
Symbol Table 1
*
Header Card
*
The symbol table 1 header card
may be recognized by the Hollerith
character STl punched in columns
1, 2, and 3.
"S" in Hollerith code
is a 0 - 2 punch. "T" is a
O -
3 punch.
The code for "1" is a 1 punch.
~&V&~~V~~@--------------------------
A-7
Advertisement
Table of Contents
