What Is Included In The Box; Initial Setup - Sharp CP-AWS0101 Quick Start Manual

6
CE and UKCA statement:
• Hereby, Sharp Consumer Electronics Poland sp. z o.o. declares that
this audio device is in compliance with the essential requirements and
other relevant provisions of RED Directive 2014/53/EU and UK Radio
Equipment Regulations 2017.
• The full CE text and UKCA declaration of conformity are available at
sharpconsumer.eu and then entering download section of your model
and choosing "Declaration of Conformity".
Compatibility warning
TV compatibility
• These speakers work exclusively with AQUOS Wireless Surround (AWS)
enabled SHARP TV's only. Please check you have the correct model
of SHARP TV. To find compatible models, scan the QR code at the
beginning of this user guide.
Wireless signal
• You will need to be connected to a 5GHz Wi-Fi network for the best
wireless speaker performance. If a 5G Wi-Fi network is not available, a
2.4GHz network can be used.
A 2.4GHz network is more prone to interference and may impact
wireless speaker performance.
The 5 GHz WLAN function of this equipment may only be
operated indoors.
WLAN max transmitter power:
100 mW at 2,400 GHz – 2,4835 GHz
100 mW at 5,150 GHz – 5,250 GHz
100 mW at 5,250 GHz – 5,350 GHz
100 mW at 5,470 GHz – 5,730 GHz
100 mW at 5,735 GHz – 5,835 GHz
BT max transmitter power: 10 mW at 2,402 GHz – 2,480 GHz.

What is included in the box:

• CP-AWS0101 Subwoofer
• Power adapter with type C (EU 2 pin) and type G (UK 3 pin) cables
• Raised feet x4
• User documentation
Inputs/outputs
(Refer to 1 on page 3).
1. LED Indicator
• Standby / Disconnected - Red
• Firmware update failed - Red (flashing)
• Pairing - Green (flashing)
• Connected - Green
• Firmware update in progress - Yellow
2. Pair button
PAIR
• Short press to enter pairing mode.
• Long press (>5 seconds) to reset
3. Upgrade Button
(For firmware upgrade use only)
4. Micro USB
(For firmware upgrade use only)
5. Power cable clip
6. DC IN socket
Socket for connecting power adapter (DC 18V/2.5A)
7. Rubber foot/screw hole cover locations (x4). These are numbered
1 - 4.
Initial set up
Placement of the subwoofer
To enjoy enhanced bass from your Sharp AWS enabled TV, you can place
the subwoofer anywhere on the floor of the room with the TV, but here
are some general locations:
1. Place the subwoofer upright on the floor close to your TV (Refer
to 2 on page 4). If you choose to place the subwoofer like this,
ensure the x4 rubber screw hole covers are in place (Refer to
on page 4). Each rubber cover is numbered. Ensure you match the
correct number on the rubber cover to the number seen on the
subwoofer.
2. Place the subwoofer on the floor under some furniture like a sofa
(Refer to 4 on page 4). If you choose to place the subwoofer
like this, ensure the x4 rubber feet are correctly installed (Refer to
5 on page 4). Each rubber foot is numbered. Ensure you match
the correct number on the rubber foot to the number seen on the
subwoofer.
Connect to power
Risk of product damage! Ensure that the power supply voltage
corresponds to the voltage printed on the back or the underside of the
unit.
Connect the power adapter to the DC IN socket of the unit and then into
a mains socket.
3