Advertisement
Positioning and levelling
To allow easy movement, the machine is
fitted with 2 fixed wheels located at the
rear of the base plus a third small
retractable wheel which can be dropped
by turning the special lever (fig. 3-4) to
the left.
To steady the machine, return the lever
back to its original position (fig. 3).
To keep vibration, noise and movement
to a minimum, it is essential that the
machine is absolutely level. Check this
with the aid of a spirit level when the
machine is in its permanent operating
position. Any adjustments needed can be
made by raising or lowering the two
adjustable feet at the front of the
machine — you merely screw them up or
down (figure 5).
Some vibration is inevitable, especially if
mounted on a wooden floor, so make
3
6
sure there is a gap of at least 12mm
(W') between the machine and any walls,
furniture and so on.
The plumbing connections
In order to make your new Zanussi
washing machine as convenient to use as
possible it has been designed to be
permanently plumbed-in to your home's
water supply and drainage system.
However, if this is not possible it may be
connected to suitable existing taps, with
the drain hose discharging into a sink.
Tap connections
For
diameter gas thread tap
connectors simply attach to %" diameter
inlet hoses on the machine. For any other
diameter you will have to get special
adaptors, either from a plumber or a
4
Advertisement
