Advertisement
4.2.
SUPPORT LEG AND WHEEL ASSY (fig.3)
4.2.1.
Attach the Support (A) to the main body by using Nut M8 (I).
4.2.2.
Install the wheels on both sides to the main body by using Tyres (C) , Wheel Axle (B) ,
Bolt M8x20 (F), Ø8 Spring Washer (G) and Ø8x20x2 Flat Washer (H).
4.3.
FEED HOPPER ASSY (fig.4, fig.5)
4.3.1.
Open the main body cover by loosening the screw.
4.3.2.
Install the Feed Hopper(D) to the main body by using Ø8 Flat Washer(J) , Ø8 Spring
Washer (G) and Nut M8 (I).
4.3.3.
Close the main body cover by retightening the screw
4.3.4.
Connect the wire connector
4.4.
DISCHARGE PORT(fig.4)
4.4.1.
Install the Discharge Port (E) to the main body cover by using Bolt M6x12 (K),
Nut M6 (O), Bolt M6x20 (N), Ø6xØ18x1.6 Flat Washer (M) and Wing Nuts (L).
fig.4
5. OPERATION
5.1.
CONTROLS (fig.6)
Throttle Control
Choke Lever
Fuel Valve Control
fig.6
5.1.1.
IMPORTANT: Ensure engine has correct oil level prior to each use.
5.2.
FUEL VALVE CONTROL (fig.6) The fuel valve opens and closes the fuel line between the fuel tank and the carburettor. The fuel
valve lever must be in the ON position for the engine to run. When the engine is not in use, leave the fuel valve lever in the
OFF position to prevent carburettor flooding and to reduce the possibility of fuel leakage.
5.3.
THROTTLE CONTROL LEVER (fig.6)
5.3.1.
The throttle lever controls engine speed. Moving the throttle lever makes the engine run faster or slower.
5.4.
ENGINE ON/OFF SWITCH (fig.6)
5.4.1.
The engine switch enables and disables the ignition system. The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
5.5.
CHOKE LEVER (fig.6)
5.5.1.
The choke lever opens and closes the choke valve in the carburettor. The closed position enriches the fuel mixture for starting a cold
engine.
5.5.2.
The open position provides the correct fuel mixture for operation after starting, and for restarting a warm engine.
© Jack Sealey Limited
Recoil Starter
Original Language Version
fig.5
ON / OFF
Switch
SWC420
Issue 1
fig.3
07/11/23
Advertisement
